The Fusing Interlining uses different heat dissolving glue, and the adhesive effect of the fabric is quite different. Therefore, in general, the Fusing Interlining is classified according to the type of hot melt adhesive, and can be divided into the following four kinds:
(1) Polyamide (PA) bonding lining: made of three or more different nylon monomers copolymerization, monomer composition and monomer ratio are different, resulting in different thermosol properties, but after bonding have a good feel (soft, elastic) and higher adhesive strength, better dry cleaning resistance, more. For men's and women's suits and coats.
(2) Polyethylene (PE) Fusing Interlining (with high density and low density): High density polyethylene has a good stiffness, water-washing resistance, dry cleaning resistance, but must be at a higher temperature and pressure to have a better effect, widely used in shirt bonding; low density polyethylene water-washing and dry cleaning resistance are poor, but can be. It can be bonded at low temperature and has good adhesion strength, so it is widely used for temporary adhesion.
(3) Polyester (PES) bonding lining: It is made by copolymerization of dicarboxylic acid and diol, and has better washing and dry cleaning resistance. It has higher bonding strength to polyester fabric, and is mainly used for polyester silk-like fabric, especially suitable for thin silk-like fabric and thick wool-like fabric.
(4) Vinyl vinyl acetate (EVA) Fusing Interlining: copolymerized by ethylene and vinyl acetate, ethylene and vinyl acetate combination can obtain low melting point hot sol, only with a hot bucket can be completed bonding processing, water resistance, dry cleaning are poor, suitable for fur clothing.
CHANGXING KIND CLOTHING MATERIAL CO., LTD
Add：longshan industrial zone, shui kou, changxing, Zhejiang